• PLC touchscreen control and foot pedal operation
• Positioning of electrode slot with adjustable position and width
• Adjustable tension, winding speed, and winding cycles
• High winding alignment accuracy
• Manual loading and unloading of electrode sheets, automatic winding
• Adjustable separator tension control
• Small footprint for laboratory use

• AC220V±10%, Single-phase, 50/60Hz

Cylindrical Winding

• Winding round needle size: φ3.5 or 4 mm OD (Any sizes between φ3-7 mm can be customized)

• Electrode size for winding: L: 500-900 mm, W: 28-68 mm, T: 0.1-0.5 mm

• Electrode alignment accuracy: ≤ ± 0.5 mm edge roughness
• Separator alignment accuracy: ≤ ± 0.5 mm edge roughness

• 3 inch core, Max. diameter of 150 mm
• Tape Width: 8-60mm, thickness: 0.01-0.035 mm 

• ~ 300K times

Compressed Air

• Compressed air of 0.5-0.8 MPa is needed for the operation of this machine.
• Please note the air compressor is not included. Please click the picture on the left to order one at MTI, or order it from your local hardware store.
• Attention: If a gas cylinder is used instead of an air compressor(pic2), a two-stage pressure regulator(pic1) must be installed on the gas cylinder to limit the pressure within the required working range for safe operation. Click here to learn the installation of a gas regulator

• An automatic tape dispenser is included for strapping the finished electrode core with tapes
• 220 VAC 50/60 Hz, 160 W
• Cutting length range: 13 – 60 mm adjustable
• Tape width range: 3 – 22 mm adjustable
• Tape roll size: 25, 32, 75 mm ID, up to 130 mm OD
  

• CE Certified
• NRTL or CSA Certification is available upon request at extra cost

• Place the machine on a flat surface free of vibration to avoid tipping of the machine
• Do not change the factory settings of air cylinders without consulting MTI. Beware not to change the air cylinder settings by accident.
• Take extra caution when operating the cutter and motor to avoid possible physical injury! Do not touch the cutter with your hand! Do not put a hand close to the cutter while the equipment is operating! Do not let hands, hair, or clothes get caught in the rolling - clamping - winding assembly! Put up warning signs, and warn other people to stay clear of the equipment.